This is the readme for VitalsBridge Connector software for VitalsBridge 2.0 units. IMPORTANT: Please ensure you are using the correct software! There is a different version of the VitalsBridge Connector for VitalsBridge models 300, 200, and 100. The VitalsBridge software is used with the VitalsBridge Instrumentation, please contact support@vitalsbridge.com for more information regarding the VitalsBridge. ------------- Version 2.11.0 ------------- Compatible with LLEAP 6.6 ------------- Version 2.10.0 ------------- Compatible with LLEAP 6.5 ------------- Version 2.9.1 ------------- Compatible with LLEAP 6.4 ------------- Version 2.8.0 ------------- Compatible with LLEAP 6.3 Improved checking for when SpO2 warning message is shown ------------- Version 2.7.0 ------------- Compatible with LLEAP 6.2 Invasive blood pressure waveforms are automatically generated if they are not sent via LLEAP. When the patient is apneic, the connector software now polls for positive pressure breaths and sets the impedance respiratory rate based on these values. -------------- Version 2.6.3: ------------- Fixed a bug where plethymograph is lost when ABP is flat-lined (i.e., for zeroing the monitor). Now plethymograph will continue (if set blood pressure is adequate) irrespective of whether ABP is flat-lined. Provided an automatic workaround to an issue where after pausing LLEAP for several minutes, the simulator's waveforms/vitals no longer are sent appropriately to the VitalsBridge connector once unpaused. -------------- Version 2.6.2: -------------- Updated to support LLEAP 6.1 Fixed serial port bug with some PCs (e.g., Panasonic ToughPad) Support for ECG generation (off by default in preference to using Manikin's internally generated ECG) ------------ Version 2.4: ------------ Updated to support LLEAP 5.4. Now has serial port capabilities for compatibility with manikins other than SimMan 3G and SimMan Essential. Note: Legacy (non-LLEAP) is no longer supported by VitalsBridge. ------------ Version 2.3: ------------ Updated to support LLEAP 5.3 Note: Legacy (non-LLEAP) users should continue to use VitalsBridge_SimMan3G_LEGACY_v2.2.0.msi, and this is the final VitalsBridge software release for the Legacy instructor application. ------------ Version 2.2: ------------ Updated to support LLEAP 5.2 Fixed a bug where temperature offsets (if selected) were not properly updating upon startup of VitalsBridge Minor formatting fixes ------------ Version 2.1: ------------ Updated to support LLEAP 5.1 Added PCWP waveform to VitalsBridge (user selectable checkbox to toggle between PAP and PCWP) Added option for manual offset of temperature in VitalsBridge UI to address incompatibily issue when some vital signs monitors when invasive blood pressures are connected (e.g., Spacelabs) Simplified 6 point CO2 calibration Fixed bug to improve accuracy of CO2 waveform shape Fixed bug where user can accidentally close VitalsBridge UI while it is running Compatible with legacy 1.1 VitalsBridge (VA Healthcare system only) Added alerts for checking NIBP Cuff (firmware versions 2.1 and higher) and SpO2 probe detection Version 2.0.3: -------------- Fixed Bug: Installer failing on older Windows Operating Systems Fixed Bug: Issue with CO2 sometimes behaving erratically during calibration This release of the VitalsBridge software is now LLEAP compatible (two installers, one for LLEAP and one for legacy) Version 2.0.2: --------------